進口程序準備中，近期開放購買。
注意：目前價格僅供參考。
ATmega328與Arduino的Optiboot（宇野）
原名
ATmega328 with Arduino Optiboot (Uno)
貨號
DEV-10524
特價
182
資料來源：https://www.sparkfun.com/products/10524
The name says it all on this one. An ATmega328P in DIP package, pre-loaded with the Arduino Optiboot (Uno 16MHz) Bootloader. This will allow you to use Arduino code in your custom embedded project without having to use an actual Arduino board.
To get this chip working with Arduino IDE, you will need an external 16MHz crystal or resonator, a 5V supply, and a serial connection. If you are not comfortable doing this, we recommend purchasing the Arduino Uno board that has all of these built into the board.
Atmel’s ATMega328P 8-Bit Processor in 28 pin DIP package. It’s like the ATmega168, with double the flash space. 32K of program space. 23 I/O lines, 6 of which are channels for the 10-bit ADC. Runs up to 20MHz with external crystal. Package can be programmed in circuit. 1.8V to 5V operating voltage!
Note: This microcontroller is in fact the ATmega328P, not the original ATmega328 and contains the bootloader used on the Arduino Uno, with small modifications to work more reliably with different serial connection options (mainly the FTDI). Check the link below for more information.
Documents:
這個名字說，這一切在這一個。在DIP封裝的ATmega328，預裝了Arduino的Optiboot（宇野16MHz的）的Bootloader。這將允許您使用Arduino的代碼定制的嵌入式項目，而無需使用一個實際的Arduino板。
要獲得此芯片的Arduino IDE工作，您將需要一個外部16MHz晶振或諧振器，5V電源和一個串行連接。如果你不舒服這樣做，我們建議購買的Arduino的烏諾具有所有這些內置到主板板。
Atmel的ATMega328 8位處理器的28腳DIP封裝。這就像ATmega168的，採用雙閃存空間。程序空間32K。其中6個23個I / O口線，都為10位ADC通道。運行到與外部晶振為20MHz。包可以在電路進行編程。 1.8V至5V的工作電壓！
注意：這包含在Arduino的烏諾使用的引導程序，小的修改不同的序列連接選項（主要是FTDI）更可靠地工作。檢查下面的鏈接了解更多信息。
文件：
替代： DEV-09217
