資料來源:https://www.seeedstudio.com/96Boards-UART-p-2525.html
This adapter is a USB to UART interface to be used with any base board compatible with the 96Boards Consumer Edition or Enterprise Edition specifications.
It makes it easy to connect your PC to the serial console on the 96Boards low-speed expansion connector, without worrying about pinout or level shifting for 1.8V IO. It also provides remote control of the power button and reset signals so that the base board can be completely controlled over a single USB cable.
Since it uses the FT230X chip from FTDI, when it is connected to your PC over USB, it appears as a normal UART interface on a PC, Macintosh or Linux computer with an FTDI UART driver installed
Features
Attaches to 96Boards low-speed (LS) expansion connector
FT230X USB to UART adapter chip
USB bus powered. Doesn‘t disconnect when base board power is cycled
Switchable between LS UART0 and UART1. (UART1 is the default console)
CTS/RTS with using UART0
TX and RX LEDs
Remote control of baseboard reset and power signals
Base board reset button
TX and RX LEDs
User LED connected to GPIOB (GPIOA on v1.0 of the adapter)
Tech support
This product is desiged by 96 boards, For any technical support or suggestion, please kindly go to their forum.
Dimensions | 80mm x 120mm x 19.6mm |
Weight | G.W 6g |
Battery | Exclude |
96Boards UART (part # 96B-05UART-V1.1) | 1 |
2mm shunts | 2 |
此配接器是一個 USB 到 UART 介面, 可與任何與96Boards 消費者版或企業版規範相容的底板一起使用。
它使您可以輕鬆地將您的 PC 連接到96Boards 低速擴展連接器上的串列主控台, 而無需擔心 1.8V IO 的線或電平移動。它還提供了電源按鈕的遠端控制和重定信號, 使基板可以完全控制在單個 USB 電纜上。
因為它使用 FT230X 晶片從 FTDI, 當它通過 USB 連接到您的個人電腦, 它出現作為一個正常 uart 介面在個人電腦, Macintosh 或 Linux 電腦與 FTDI uart 驅動程式安裝
功能
附加到96Boards 低速 (LS) 擴展連接器
FT230X USB 到 UART 配接器晶片
USB 匯流排供電。當底板電源迴圈時不斷開連接
UART0 和 UART1 之間的切換。(UART1 是預設主控台)
使用 UART0 的 CTS/RTS
TX 和 RX 指示燈
底板重定和電源信號的遠端控制
底板重定按鈕
TX 和 RX 指示燈
使用者 LED 連接到 GPIOB (GPIOA v1.0 配接器)
技術支援
此產品由96板 desiged,對於任何技術支援或建議, 請轉到他們的論壇.
尺寸 | 80mm x 120mm x 19.6mm |
重量 | G. W 6g |
電池 | 排除 |
96Boards uart (96 部分 b-05 uart-V1.1) | 1 |
2mm 分流 | 2 |