進口程序準備中，近期開放購買。
注意：目前價格僅供參考。
SparkFun RFID讀寫器突圍
原名
SparkFun RFID Reader Breakout
貨號
SEN-13030
特價
64
資料來源：https://www.sparkfun.com/products/13030
This is a simple breakout board for our RFID readers. The SparkFun RFID Reader Breakout converts the 2mm pins to bread board friendly 0.1" headers. With this ability the ID-3LA, ID-12LA, and the ID-20LA you can solder the reader directly to the breakout board or use the 2mm sockets.
This breakout board’s edges actually fit flush within the under side the ID-12LA. The board also works with the ID-20LA, but is smaller than the edges. As stated before each pin of the RFID reader has been broken out including: VCC, READ, D0, D1, FORM, TIR, CP, both ANTs, RES, and GND. We’ve even added four half-mounting holes to the board to easily secure your project!
Note: If you are concerned about soldering this board directly to the RFID reader, you can use 2mm sockets instead. This is due to the RFID being sensitive to heat and should be handled with care or if you would like to switch the readers out as you please.
Documents:
- Schematic
- Eagle Files
- Using the RFID Reader Breakout
- GitHub (Design Files)
- Product Video
這是我們的RFID閱讀器一個簡單的接口板。在SparkFun RFID閱讀器突圍轉換2mm的引腳麵包板型0.1“的標題。有了這種能力的ID 3LA，ID-12LA和ID-20LA，您可以直接焊接讀者突破板或使用2mm的插座。
該接口板的邊緣實際上是適應下側的ID-12LA內沖洗。該板也可與ID-20LA，但是比邊緣小。如所陳述的RFID讀取器的每個銷已被打破了，包括之前：VCC，READ，D0，D1，FORM TIR，CP，既ANTS，RES和GND。我們甚至還增加了四個半安裝孔，董事會輕鬆地保護您的項目！
注意：如果你擔心直接焊接這款主板的RFID閱讀器，你可以使用2毫米插槽來代替。這是因為RFID是對熱敏感，應小心或處理，如果你想切換讀者了，請你。
文件：
