進口程序準備中，近期開放購買。
注意：目前價格僅供參考。
力敏電阻器0.5“
原名
Force Sensitive Resistor 0.5"
貨號
SEN-09375
特價
229
資料來源：https://www.sparkfun.com/products/9375
This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR its resistance will be larger than 1MΩ. This FSR can sense applied force anywhere in the range of 100g-10kg.
Two pins extend from the bottom of the sensor with 0.1" pitch making it bread board friendly. There is a peel-and-stick rubber backing on the other side of the sensing area to mount the FSR.
These sensors are simple to set up and great for sensing pressure, but they aren’t incredibly accurate. Use them to sense if it’s being squeezed, but you may not want to use it as a scale.
Note: As it states in the Integration Guide, do NOT solder directly to the exposed silver traces. With flexible substrates, the solder joint will not hold and the substrate can easily melt and distort during the soldering. We recommend using a male or female clincher connector instead.
Get Started with the Force Sensitive Resistor Guide
Features:
- Overall length: 2.375"
- Overall width: 0.75"
- Sensing diameter: 0.5"
Documents:
Videos
這是一個圓形，0.5“直徑，感測區域上的力敏感電阻。此FSR將取決於正在被多大的壓力施加於感測區域而改變它的電阻。該較硬的力，電阻越低。當沒有壓力被施加到FSR其電阻將大於1MΩ大。這FSR能感受到百克-10公斤的範圍內的任何地方施加力。
兩個銷從傳感器的底部延伸以0.1“間距使得麵包板友好。上有傳感區域裝入FSR的另一側的剝離和棒橡膠襯裡。
這些傳感器是簡單的設置和偉大的感應壓力，但他們不是非常準確。用它們來檢測，如果它受到擠壓，但你可能不希望使用它作為一個規模。
外形尺寸：
- 總長度：2.375“
- 總寬：0.75“
- 傳感直徑：0.5“
文件：
