資料來源:https://www.sparkfun.com/products/9068
The serial enabled LCD allows you to control a parallel based LCD over a single-wire serial interface. Included in this product is a red on black 16x2 LCD connected to our serial backpack. The backpack, based around a PIC16LF88, takes a TTL serial input and prints the characters it receives onto the LCD. The installed firmware allows for a number of special commands so you can clear the screen, adjust the backlight brightness, turn the display on/off, and more.
Communication with SerLCD requires 3.3V TTL serial at a default baud rate of 9600bps (8-N-1). You can adjust the baud to any standard rate between 2400 and 38400bps. The power, ground and RX pins are all broken out to a 3.5mm pitch screw terminal.
SerLCD has the ability to dim the backlight to conserve power if needed. There is also a potentiometer on the backpack to adjust the contrast.
Note: Though the silkscreen may say ‘5V’, this is a 3.3v Serial LCD. Connect to a 3.3v power source.
Features:
Documents:
串行啟用LCD可以讓你在一個單一的線式串行接口控制並行基於LCD。包括在這個產品是連接到我們的串行背包黑色16×2液晶顯示屏上紅色。背包,四處PIC16LF88基礎,需要一個TTL串行輸入並打印接收到LCD的字符。安裝的固件允許一些特殊的命令,這樣你就可以清除屏幕,調整背光亮度,打開顯示開/關,等等。
與SerLCD通信需要為9600bps的默認波特率(8-N-1)的3.3V的TTL串行。您可以調整2400和38400BPS的波特率以任何標準速率。電源,地和RX引腳都突破至一個3.5mm螺距螺紋端子。
SerLCD有暗淡的背光如果需要節省電力的能力。還有放在背包一個電位器來調節對比度。
注:雖然絲印可能會說'5V',這是一個3.3V系列LCD。連接到3.3V電源。
特徵:
尺寸:1.425x3.15“ - 1”厚
文件: