進口程序準備中,近期開放購買。

注意:目前價格僅供參考。

SparkFun串行基本突圍 - CH340G

原名
SparkFun Serial Basic Breakout - CH340G

貨號
DEV-14050

特價
229

資料來源:https://www.sparkfun.com/products/14050

The SparkFun Serial Basic Breakout is an easy-to-use USB-to-Serial adapter based on the CH340G IC from WCH. It works with 5V and 3.3V systems and should auto install on most operating systems without the need for additional drivers. The Serial Basic uses the CH340G IC to quickly and easily convert serial signals to USB. It’s a great lower-cost alternative to the extremely popular FTDI Basic.

The pinout of the Serial Basic mimics the common DTR/RX/TX/VCC/CTS/GND pinout found on hundreds of FTDI-to-USB derivatives. It can also be used as a general serial device for debugging (such as with a GPS module). There is a jumper on the rear of the board that controls the output voltage on the VCC pin. By default, the board outputs 3.3V and has 3.3V signals. Changing this jumper to 5V will cause the board to output 5V on the VCC pin with 5V signals.

Get Started with the Serial Basic Breakout

Documents:

在SparkFun串行基本突圍是一個基於從WCH的CH340G IC一個易於使用的USB轉串口適配器。它與5V和3.3V系統,並應自動在大多數操作系統上安裝,無需額外的驅動程序。串行Basic使用CH340G IC快速,方便地轉換成串行信號轉換為USB。這是一個偉大的低成本替代極受歡迎FTDI基礎

串行基本模仿的引腳共同DTR / RX / TX / VCC / CTS / GND引腳上的數百個FTDI到USB衍生物的發現。它也可以用作一般串行設備用於調試(如與GPS模塊)。有於控制VCC引腳上的輸出電壓電路板的背面跳線。默認情況下,板輸出3.3V和3.3V有信號。更改該跳線至5V將導致板輸出5V與5V的信號VCC引腳上。

開始使用串行基本突圍指南

文件:

前往
現貨型錄

Line share