資料來源:https://www.seeedstudio.com/Blueduino-Rev2--Arduino-compatible-pius-BLE-CC2540-p-2550.html
The BlueDuino Rev2 is an Arduino compatible microcontroller development board based on the ATmega32U4 IC with Bluetooth 4.0. a.k.a. Bluetooth Low Energy (BLE), built in. Just plug in the board and your ready to start programming! It's the easiest way to get Bluetooth 4.0 in your project!
The BlueDuino Rev2 is tiny size Arduino compatible dev board. It's built-in a cc2540 BLE module. The BLE module can work as master or slave mode.
Features
Built-in CC2540 BLE module
ATmega32U4 running at 3.3V/8MHz
Supported under Arduino IDE 1.0.6
On-Board micro-USB connector for programming
4 x 10-bit ADC pins
12 x Digital I/Os (5 are PWM capable)
Rx and Tx Hardware Serial Connections
Firmware For CC2540
The firmware for CC254x BLE module named ZeroBeacon.
Application iBeacon simulation / iBeacon sniffer / BLE Sensor
Support UART transparent transfer.
Support AT commands
Support upgrade the firmware by serial port.
Getting Started
Open Arduino IDE and choose board"LilyPad USB"to start playing with your BlueDuino Rev2 in just a few easy steps.
How it works
The CC254x module communicates with ATMega32U4 through the HardwareSerial Serial1 (RX1, TX0).
Part List
1 x BlueDuino Rev2
1x Male headers (Not soldering)
(LiPo battery charger add-on now available.)
Weight | G.W 8g |
Battery | Exclude |
BlueDuino Rev2 是一個 Arduino 相容的微控制器開發板基於 ATmega32U4 IC 與藍牙4.0。又稱藍牙低能量, 內置。只需插入板和您的準備開始程式設計!這是最簡單的方法獲得藍牙4.0 在您的專案!
BlueDuino Rev2 是小尺寸 Arduino 相容的開發板。它是建立在一個 cc2540 的模組。該模組可以作為主從模式工作。
功能
內置 CC2540 模組
ATmega32U4 運行在 +3.3v/8 mhz
在 Arduino IDE 1.0.6 下支援
用於程式設計的車載微 USB 連接器
4 x 10 位 ADC 針腳
12 x 數位 i/o (5 是 PWM 能力)
Rx 和 Tx 硬體串列連接
CC2540 固件
CC254x 的固件模組名為 ZeroBeacon。
應用 iBeacon 模擬/iBeacon 探測器/感應器
支援 UART 的透明傳輸。
命令支援
支援通過序列埠升級固件。
入門
打開 Arduino IDE, 並選擇主機板 "百合鎮 USB" 開始玩你的 BlueDuino Rev2 只需幾個簡單的步驟。
它是如何工作的
CC254x 模組通過 HardwareSerial Serial1 (RX1, TX0) 與 ATMega32U4 通信。
部件清單
1 x BlueDuino Rev2
1x 男性頭 (不焊接)
(充電電池充電器添加-現在可用。
重量 | G. W 8g |
電池 | 排除 |