113990034 Arduino Ethernet WITHOUT PoE + USB2SERIAL推薦購買

原名

貨號

113990034

分類

Arduino & Compatible

特價

商品停售

由於停止生產、銷量不佳、升級改版... 或其他因素，SeeedStudio 原廠目前已經停止生產、供應、或銷售本件商品，請尋找其他替代品方案。

資料來源：https://www.seeedstudio.com/Arduino-Ethernet-WITHOUT-PoE-%2B-USB2SERIAL-p-1068.html

Description

This product is retired, please consider our Seeeduino Ethernet as your alternative choice.

Arduino Ethernet w/o PoE module

The Arduino Ethernet is a microcontroller board based on the Arduino Uno, and incorporating a WizNet W5100 TCP/IP Embedded Ethernet Controller. It can be programmed like an Uno via a six-pin FTDI -style serial connector. The Arduino USB 2 Serial adapter or any FTDI-style USB-to-serial connector can be used to program it.

A separate power-over-Ethernet (PoE) module can be soldered to the board to provide power from a conventional twisted pair Category 5 Ethernet cable. It is IEEE802.3af compliant, and works with all compliant PoE injectors currently available.

Specifications

Microcontroller ATmega328
Operating voltage 5V
Input voltage (recommended) 7-12V
Input voltage (limits) 6-20V
Digital I/O pins 14 (of which 4 provide PWM output)
Arduino pins reserved
- 10 to 13 used for SPI
- 4 used for SD card
- 2 W5100 interrupt (when bridged)
Analog input pins 6
DC current per I/O pin 40 mA
DC current for 3.3V pin 50 mA
Flash memory 32 KB (ATmega328) of which 0.5 KB used by bootloader
SRAM 2 KB (ATmega328)
EEPROM 1 KB (ATmega328)
Clock speed 16 MHz
W5100 TCP/IP Embedded Ethernet Controller
Power Over Ethernet ready Magnetic Jack
Micro SD card, with active voltage translators

USB 2 Serial Converter

This board converts a USB connection into 5 volt TX and RX that you can connect straight to the Arduino Ethernet or any other boards with an FTDI cable-compatible connector.

It features the Atmega8U2 programmed as a USB-to-serial converter, the same chip found on the Arduino Uno. The USB Serial module has an ISCP interface, allowing you to reprogram the chip when placed in DFU mode.

The pinouts on the connector are compatible with a standard FTDI header (as well as the Adafruit and Sparkfun USB-Serial adapters).

描述

此產品已退役, 請考慮我們的Seeeduino 乙太網作為您的替代選擇。

Arduino 乙太網 w/o PoE 模組

Arduino 乙太網是一個基於 Arduino 的單片機板, 並結合了 WizNet W5100 tcp/ip 嵌入式乙太網控制器。它可以通過一個六針 FTDI 式串列連接器來程式設計。Arduino usb 2 串列配接器或任何 FTDI 式 usb 到串列連接器均可用於對其進行程式設計。

可以將單獨的電源過乙太網 (PoE) 模組焊接到主機板上, 以便從傳統的雙絞線5級乙太網電纜中提供電源。它是 IEEE802.3af 相容, 並與所有符合要求的 PoE 注射器目前可用。

規格