資料來源:https://www.seeedstudio.com/AllPixel-Power-Tap-Kit-p-2380.html
The PowerTap is tiny (less than 1” square) accessory board for simplifying the hookup of power on long runs of LEDs. Due to voltage drops over long strips, it is recommended to inject power every 5m or 5A, whichever comes first. With the PowerTap, you can build in a quick connect/disconnect power port in between your sections of LEDs. Very basic soldering skills required to assemble the board.
Features
2.1mm DC barrel jack for input of 5-12V @ up to 5A
Input and output 0.1” spacing screw terminals. Data, Clock, and Ground are carried along to the other side while power is only sent to the output terminal to the next section of LEDs
1000uF capacitor for smoothing out power fluctuations
Part List
PowerTap board
2.1mm DC barrel jack
2x 0.1” screw terminal
1000uF Capacitor
Documents
If you have any questions, feel free to send us an email to service.
For any technical support or suggestion, please kindly go to our forum.
Dimensions | 100mm x 60mm x 10.5mm |
Weight | G.W 9g |
Battery | Exclude |
PowerTap 是微小的 (少於1平方) 的附屬板, 用於簡化電源對長時間運行的 led 的連線。由於電壓下降過長的長條, 建議每5m 或5A 注入功率, 無論哪個先來。使用 PowerTap, 您可以在 led 的各個部分之間建立快速連接/斷開電源埠。非常基本的焊接技能, 需要組裝板。
功能
2.1mm 直流桶插孔輸入 5-12V @ 5A
輸入和輸出 0.1 "間距螺絲端子。資料、時鐘和地面被帶到另一側, 而電源只發送到輸出端子到下一節的 led
1000uF 電容平滑功率波動
部件清單
PowerTap 板
2.1mm 直流桶插孔
2x 0.1 "螺絲端子"
1000uF 電容
檔
如果您有任何問題, 請隨時發送給我們電子郵件to服務
對於任何技術支援或建議, 請轉到我們的論壇.
尺寸 | 100mm x 60mm x 10.5mm |
重量 | G. W 9g |
電池 | 排除 |