資料來源:https://www.seeedstudio.com/Grove---Carbon-Dioxide-Sensor%28MH-Z16%29-p-1863.html
The Grove - CO2 Sensor module is infrared CO2 sensor high sensitivity and high resolution. Infrared CO2 sensor MH-Z16 Is a general-purpose, small sensors , the use of non-dispersive infrared (NDIR) Present in the principle of the air CO2 Detect , with good selectivity, oxygen- dependent , long life, built-in temperature sensor, temperature compensation ,with UART output , easy to use. It can be widely used in HVAC and indoor air quality monitoring , industrial process monitoring and security , agriculture and livestock production process monitoring.
NOTE
The sensor value only reflects the approximated trend of gas concentration in a permissible error range, it DOES NOT represents the exact gas concentration. The detection of certain components in the air usually requires a more precise and costly instrument, which can not be done with a single gas sensor. If your projects aims to obtain the gas concentration at a very precise level, then we do not recommend this gas sensor.
Dimensions | 100mm x 150mm x 20mm |
Weight | G.W 26g |
Battery | Exclude |
Measuring Range | 0-2000 parts per million (PPM) |
Resolution | 1 PPM 0-2000 parts per million (PPM) |
Accuracy | 200 PPM |
Warm up time | 3 minutes |
Response Time | <90s |
Operating Temperature | 0 to 50℃ |
Operating Humidity | 0% ~ 90% RH |
Storage Temperature | - 20-60℃ |
Operating Voltage | 4.5 V to 6 V DC |
Maximum Current | 100 mA |
Average Current | ≤50 ma |
Output Mode | UART |
Grove - CO2 Sensor | 1 |
Grove Cable | 1 |
CO2 感應器模組是紅外 CO2 感應器, 靈敏度高, 解析度高。紅外 CO2 感應器 MH-Z16 是一種通用、小的感應器, 利用非色散紅外 (NDIR) 的原理對空氣進行 CO2 檢測, 具有良好的選擇性、耐氧、壽命長、內置溫度感應器、溫度補償, 具有 UART 輸出, 使用方便。可廣泛應用於暖通空調及室內空氣品質監測、工業過程監控及安防、農牧生產過程監控。
注意
感應器的值只反映了氣體濃度在允許誤差範圍內的逼近趨勢, 不代表精確的氣體濃度。對空氣中某些成分的檢測通常需要更精確、更昂貴的儀器, 不能用單一的氣體感應器來完成。如果你的專案旨在獲得一個非常精確的水準的氣體濃度, 那麼我們不推薦這種氣體感應器。
尺寸 | 100mm x 150mm x 20mm |
重量 | G. W 25g |
電池 | 排除 |
測量範圍 | 每百萬0-2000 份 (PPM) |
決議 | 1 ppm 0-2000 件/百萬 (ppm) |
精度 | 200 PPM |
預熱時間 | 3分鐘 |
回應時間 | < 90s |
工作溫度 | 0至50℃ |
工作濕度 | 0% ~ 90% RH |
貯存溫度 | -20-60℃ |
工作電壓 | 4.5 v 到 6 v DC |
最大電流 | 100 mA |
平均電流 | ≤50馬 |
輸出模式 | uart |
格羅夫-CO2 感應器 | 1 |
格羅夫電纜 | 1 |