代理經銷軟硬體精選系列產品
Raspberry Pi 樹莓派
STM Nucleo
STM Discovery
J-Link
TI Launchpad
TI DevPack
Matlab
Eagle
Keil
MDK
原廠提供一年售後保固服務*
FTDI - UMFT201XB-01 - FT201XQ, USB TO I2C, BREAKOUT BOARD
Accessory Type
USB to I2For Use With
-Product Range
-SVHC
No SVHC (17-Dec-2015)Features
USB Battery Charger Detection, Up to 3.4MHz, High Speed Mode, I2C SupportedBreakout Module based on FT201XQ USB to I2C Slave Interface Chip - Female Pin Connection
UMFT201XB-01 breakout modules utilize FT201XQ chip to convert USB to serial interface. UMFT201XB bridges from USB to I2C IC. This hardware is a low cost breakout board form factor that converts USB2.0 full speed to a serial interface and connects the serial signals to a 2.54mm (0.1inch) pitch 10pin female receptacle. The boards do not use a USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector. This modules operate at +3.3V voltage levels, however all I/Os are 5V tolerant.
- Single chip USB to I2C slave interface
- Up to 3.4MHz, high speed mode, I2C supported
- Entire USB protocol handled on the chip. No USB specific firmware programming required
- Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
- Configurable CBUS I/O pin
- Transmit and receive LED drive signals
- Device supplied preprogrammed with unique USB serial number
- Integrated power on reset circuit
- UHCI/OHCI/EHCI host controller compatible
- USB 2.0 Full Speed compatible
- Communications & Networking
- Industrial
- Portable Devices
- Consumer Electronics
- Wireless
- Sensing & Instrumentation
- System Monitoring
