進口程序準備中，近期開放購買。
注意：目前價格僅供參考。
公交海盜 - v3.6a
原名
Bus Pirate - v3.6a
貨號
TOL-12942
特價
988
資料來源：https://www.sparkfun.com/products/12942
The Bus Pirate v3.6a, created by Ian Lesnet, is a troubleshooting tool that communicates between a PC and any embedded device over 1-wire, 2-wire, 3-wire, UART, I2C, SPI, and HD44780 LCD protocols - all at voltages from 0-5.5VDC. This product eliminates a ton of early prototyping effort when working with new or unknown chips.
Working with the Bus Pirate is simple and effective - type commands into a terminal on your computer, those commands are interpreted by the Bus Pirate and sent via the proper protocol. The Pirate will also interpret data sent from your embedded device back to your computer terminal. A big bonus is the bootloader installed on the PIC, which allows you to easily update the firmware and change the functionality of the board.
The main components of the Bus Pirate are the PIC24FJ64 processor and a FT232RL USB-to-Serial chip. A Mini-B USB connector that has also been populated on the board, provides the power to the Bus Pirate and allows you to interact with via your PC. The major difference in this version of the Bus Pirate comes from the shrouded 0.1" pitch 2x5 pin header, which has been flipped around to help standardize this board. Additionally every pin on this header has been labeled, eliminating the need for a separate I/O pin description document like with earlier versions.
Note: We sell a handy cable to connect the Bus Pirate to the system you are developing, debugging, or reverse engineering.
Note: This product is a collaboration with Ian Lesnet. A portion of each sales goes back to them for product support and continued development.
Get Started with the Bus Pirate Hookup Guide
Features:
- Supported protocols:
- 1-Wire
- I2C
- SPI
- JTAG
- Asynchronous serial
- MIDI
- PC keyboard
- HD44780 LCD
- 2- and 3-wire libraries with bitwise pin control
- Scriptable binary bitbang, 1-Wire, I2C, SPI, and UART modes
- 5.5V tolerant pins
- 6V measurement probe
- 1Hz - 40MHz frequency measurement
- 1kHz - 4MHz pulse-width modulator, frequency generator
- On-board multi-voltage pull-up resistors
- On-board 3.3volt and 5volt power supplies with software reset
- Macros for common operations
- Bus traffic sniffers (SPI, I2C)
- A bootloader for easy firmware updates
- Transparent USB->serial mode
- 10Hz - 1MHz low-speed logic analyzer
- Scriptable from Perl, Python, etc.
- Access to PIC24FJ64 ICSP programming port
Documents:
總線海盜v3.6a，通過創建伊恩Lesnet ，是一個故障排除工具，一台電腦和超過1線，2線，3線，UART任何嵌入式設備之間的通信，I 2 C，SPI和HD44780 LCD協議 - 所有從0-5.5VDC電壓。與新的或未知的芯片工作時，本產品消除了一噸的早期原型的努力。
與總線海盜工作是簡單而有效 - 型的命令到您的計算機上的終端，這些命令是由總線海盜解釋，並通過適當的協議發送。海盜也會解釋從嵌入式設備發送到您的計算機終端的數據。一個巨大的獎賞是安裝在PIC的引導程序，它可以讓你輕鬆更新固件，改變董事會的功能。
總線海盜的主要成分是PIC24FJ64處理器和USB FT232RL到串行芯片。這也被填充在黑板上的Mini-B USB連接器，提供的電源總線海盜，並允許您通過您的電腦進行交互。在這個版本的總線海盜的主要區別來自於籠罩0.1“間距2×5針接頭，已經翻轉繞到利於規範這款主板，另外在這頭每針已經被貼上標籤，無需單獨的我需要/ O引腳描述文檔就像早期版本。
注意：我們出售方便的電纜到總線海盜連接到您正在開發的系統，調試或反向工程。
注：本產品是與伊恩Lesnet協作。每一個銷售的部分可以追溯到他們的產品支持和持續發展。
特徵：
- 支持的協議：
- 1線
- I 2 C
- SPI
- JTAG
- 異步串行
- MIDI
- PC鍵盤
- HD44780 LCD
- 2線和3線庫按位引腳控制
- 腳本化二進制bitbang，1線，I 2 C，SPI和UART模式
- 5.5V耐壓引腳
- 6V測量探頭
- 為1Hz - 40MHz的頻率測量
- 為1kHz - 4MHz的脈衝寬度調製器，頻率發生器
- 板上的多電壓上拉電阻
- 板載3.3volt和其它5伏特電源與軟件復位
- 宏常用操作
- 總線流量嗅探器（SPI，I 2 C）
- 一個方便的固件更新引導程序
- 透明的USB - >串行模式
- 為10Hz - 1MHz的低速邏輯分析儀
- 在Perl，Python等腳本化
- 訪問PIC24FJ64 ICSP編程口
文件：
