資料來源:https://www.sparkfun.com/products/258
The SparkFun Serial Enabled LCD Backpack allows you to control a parallel based LCD over a single-wire serial interface. The SerLCD backpack takes care of all the HD44780 commands allowing seamless integration with any micro that can communicate over a wide range of TTL serial baud rates. The SerLCD currently supports 16 and 20 character wide screens with 2 or 4 lines of display.
Communication with SerLCD requires 5V TTL serial at a default baud rate of 9600bps (8-N-1). You can adjust the baud to any standard rate between 2400 and 38400bps. The power, ground and RX pins are all broken out to a 3.5mm pitch screw terminal.
SerLCD has the ability to dim the backlight to conserve power if needed. There is also a potentiometer on the backpack to adjust the contrast.
Note: The SerLCD v2.5 Datasheet incorrectly identifies the PIC as a 16F688, when it’s actually a 16LF88. Sorry for blowing your mind.
Features:
Documents:
啟用LCD背包SparkFun串口可以讓你在一個單一的線式串行接口控制並行基於LCD。該SerLCD背包照顧所有的HD44780命令允許與可以在很寬範圍的TTL串口的波特率通信的任何微小的無縫集成。該SerLCD目前支持16和20個字符的2個或4行顯示的寬屏。
與SerLCD通信需要為9600bps的默認波特率(8-N-1)5V TTL串口。您可以調整2400和38400BPS的波特率以任何標準速率。電源,地和RX引腳都突破至一個3.5mm螺距螺紋端子。
SerLCD有暗淡的背光如果需要節省電力的能力。還有放在背包一個電位器來調節對比度。
注:SerLCD V2.5數據表不正確地識別PIC為16F688,當它實際上是一個16LF88。對不起,吹你的頭腦。
特徵:
文件:
尺寸:0.56“×1.75”